Whitelist / Blacklist SPAM Filtering in Plesk 12

How to Setup Whitelist / Blacklist SPAM Filtering in Plesk 12

This knowledge article will show you how to use whitelist and blacklist to block SPAM :

  1. Login to your Plesk Control Panel

  2. After logging in, click on the "Mail" tab



  3. Next, click on the Email address you want to implement Whitelist / Blacklist SPAM filtering



  4. Next, click on the "Spam Filter" tab.



  5. Next check the box "Switch on spam filtering for this email address".



  6. Finally, scroll down the page to the bottom where you see "White List" and "Black List".
    This is where you can specify emal addresses to block or allow.

    a. To block all emails from a domain, enter the domain name e.g. "*@domain.com" in a new line.
    b. To block a single email address, enter the email addess e.g. "user@domain.com" in a new line.

    These same syntax applies for both White and Black List.



  7. To save your changes, click on the "OK" button
  • 1 Users Found This Useful
Was this answer helpful?

Related Articles

Setting Up E-mail Clients

Email configuration standard We use the standard email configuration for all of our services....

About Email

Our email serviceWith our email service, you are able to accept messages using an email client...

Setting Up Outlook Express 4

Instructions Here are the steps to configure Outlook Express 4 : Launch Outlook Express. From...

How to view message headers from the email?

Introduction This article shows you how to see the email header. Headers contain tracking...

Setting up Thunderbird

Instructions Here are the steps to configure Thunderbird (This example is for Thunderbird on...